Installation instructions:
Step 1:
Install the aluminum crossbar underneath the engine mount support bars as shown in the photos below. Use the provided clamps and bolts/nuts to secure in place.
(View facing forward from the left side of the aircraft)
|
(View facing forward from the right side of the aircraft)
|
Step 2:
Then attach the Electronics Fuse Box on top and align the rubber mounts with the mounting holes already set on your fuse box. Use the photos both above and below as a guide.
Step 3:
Use the two remaining clamps and rubber mounts to attach the unattached side (the front) of the Fuse box securely down to the Engine Mount.
View looking forward from the left-hand side of the aircraft.
|
View looking aft from the right-hand side of the aircraft.
|
Step 4:
Now simply attach all cables and wiring to their appropriate positions on your Fuse Box. Please take note of the mounting system for the one loose wiring harness in the photo to the far right. Use the provided zip-tie and piece of rubber tubing for the mount.
|
|
Use the rubber tubing and zip tie to attach the wiring harness onto the aluminum crossbar.
|