INSTALLATION INSTRUCTIONS
STEP 1:
Connect the two upper oil radiator arms to the engine gearbox (pictures below) using the shorter bolts and lock washers. The longer bolts goes to the Rh side of the engine. Install the two stainless end brackets in the oil radiator after installing the anchor nuts in them. They are held in with the black screws, which have a lock washer and a regular washer under the head. The rubber nut plates are used as nuts on the inside of the radiator. Ensure rubber is placed towards the screw head. Do not tighten until it is fit to the nose bowl.
STEP 2:
Install the two lower oil radiator and water radiator brackets to the gearbox on each side as per the pictures below. They use the longer bolts with lock washers.
Lh side shown below.
Lh side shown below.
The rh side is shown below.
NOTE: The Rh side water radiator mounting bracket has a bump or joggle to clear the oil lines.
NOTE: The Rh side water radiator mounting bracket has a bump or joggle to clear the oil lines.
Install the water radiator with the last bracket. Be sure to use lock washers on the radiator bolts.
Water and oil radiators are now installed.
Be sure to tighten the fasteners once they have been positioned and fit to the nose bowl.
Be sure to tighten the fasteners once they have been positioned and fit to the nose bowl.
