INSTALLATION INSTRUCTIONS
Step 1: (LEFT HAND SIDE)
Cut the red hose (shown below) so that the long aluminum pipe fits inside and almost touches the left hand side of the water radiator.
Routing Photos (LEFT HAND SIDE)
These photos show the routing of the radiator connection tubes:
The following photo shows where to connect the radiator connection tube to the radiator using the shortest supplied joining hose.
Using the off-cut red hose from step one, slide it along the radiator connection tube until it provides a buffer against the ring mount as shown below. Apply silicone to prevent it from moving.
Step 2: (RIGHT HAND SIDE)
Connect the right hand radiator connection tube onto the 90-degree water pump fitting using the medium-sized hose connector.
It should extend just past the ring mount.
It should extend just past the ring mount.
Please note that the medium sized hose connector is this long on purpose as to allow for a buffer between the radiator connection tube and the ring mount on the right side.
The following photos show the routing and the use of the longest flexible tube connector to connect to the right hand side of the radiator.
|
|
Note: You can use silicone to prevent oil lines from rubbing against the radiator connection tubes as shown below: