Installation Instructions:
Step 1:
Assemble the two rivets in each top bracket. Detailed instructions for this step are available by clicking the button below:
Step 2:
Drill the cowling 1/4" mount hole in both Right-Hand and Left-Hand upper bracket assembly.
Now drill the 1/4" mounting holes for the cowl in the lower brackets:
Step 3:
Clamp all four brackets in place and Position radiator to cowl verify a even clearance between the cowl and the Radiator.
Be sure the matting surfaces are flush against the cowl.
Then mark the attachment hole positions using a pen.
Remove and review your marks to be sure it is level and even:
Be sure the matting surfaces are flush against the cowl.
Then mark the attachment hole positions using a pen.
Remove and review your marks to be sure it is level and even:
Step 4:
Drill 1/4" holes in cowl for bracket attachment as shown below:
Step 5:
|
Scribe for #10 holes in brackets:
|
Assemble as per lay of pieces:
|
Step 6:
Bolt in position on radiator:
Step 7:
Install using supplied 1/4 turn fasteners & attach your fully assembled Oil Cooler w/ brackets onto your Cowling.
