- Skytek Firewall Forward
- >
- Special Constant Duty Master Solenoid & Nylon Insulator Assembly Kit
Special Constant Duty Master Solenoid & Nylon Insulator Assembly Kit
SKU:
SFF 40AKis/5
$161.24
$161.24
Unavailable
per item
The Starter Solenoid Assembly Kit Gives You The Insulating Block For Your Starter Solenoid As Well As the CAD Plated Mounting Hardware For The Starter Solenoid & Master Solenoid Including the Insulated Jumper.
Installation Instructions:
Step 1:
Layout as shown below:
Place Nylon Insulator as shown using previously drawn lines as a corner guide. Mark the top two holes. Then take off the insulator. If you are installing the 914 version, there is no nylon insulator. Simply assemble the rest of the kit and back-drill the holes through the firewall based on the right-hand solenoid.
Step 2:
Drill four #10 holes. Drill the two holes you just marked in the above photo, and two at 153 mm and 95 mm marks you made in the first step.
Step 3:
Deburr & Install Solenoids & Insulator As Shown:
Note: The extra long bolt on the left-hand side (below the screwdriver) is for a ground.
Note: The extra long bolt on the left-hand side (below the screwdriver) is for a ground.