- Skytek Fuselage*
- >
- Skylight to Windshield Joiner Strip Kit
Skylight to Windshield Joiner Strip Kit
SKU:
SF 80K
$18.00
$18.00
Unavailable
per item
This joiner strip is for those who found that the Zenith skylight to windshield strip didn't work. We have made this one to rivet or screw onto the skylight and the windshield mounting holes.
Installation Instructions:
Step 1:
Fit the windshield strip (the larger of the two pieces included in this kit) to the bottom side of the skylight and the top side of the windshield as shown in the photos below. You may need to trim the skylight and/or windshield to fit. Clamp together so that nothing will move. Drill holes (that are a few sizes too small for the screws to fit into) through the joiner strip, windshield, and into the steel tube below. Then, using a drill bit just large enough to make a hole that the screw will go into easily, upsize the holes in the joiner strip and windshield only. Use clecos to temporarily hold this assembly together.
Note: This step is referring to the line of silver clecos in the photos below.
Note: This step is referring to the line of silver clecos in the photos below.
Step 2:
Place the original Zenith joiner on top of the skylight. The bend should be facing down. Clamp and drill through all materials (trim strip, skylight, and joiner strip) for the rivets supplied by Zenith. Cleco as you drill to prevent the pieces from shifting. Then fasten the original Zenith joiner, skylight, and Skytek joiner strip together and replace the clecos on the Skytek joiner strip with fasteners of your choice.
Note: We recommend using screws, however you may just want to use the rivets supplied by Zenith.
Note: We recommend using screws, however you may just want to use the rivets supplied by Zenith.