- Skytek Fuel System Kits
- >
- Fuel Pump Mounting Kit EXPOSED pumps only 912is, 915is, 916is
Fuel Pump Mounting Kit EXPOSED pumps only 912is, 915is, 916is
SKU:
SFS 95KEP
$275.27
$275.27
Unavailable
per item
This Fuel Pump To Firewall Mounting Kit includes all hardware to mount the electric fuel pumps to the firewall. This is for EXPOSED PUMPS ONLY. It has all the fittings required to plumb them together.
Installation Instructions:
STEP 1 Layout on firewall
Layout on firewall the two holes shown on diagonal line as shown below.
STEP 2
Assemble of fuel pumps with fittings provided to look like picture below. Note direction of pumps and direction of one way valves.
Place clamps provided with your pumps over pumps as shown and lock wire clamps in closed position as if there was a bolt in them.
Place clamps provided with your pumps over pumps as shown and lock wire clamps in closed position as if there was a bolt in them.
Place pumps in position with the two corresponding clamps over the marked holes. Verify space between battery box and pump assembly. Relocate if needed but on the diagonal line. Upper clamp can be slid on fuel pump to make things line up.
STEP 3
Drill the two marked or relocated holes to 1/4". Place AN4-6A bolts in them and position the remaining two clamps as shown above. Mark for the two holes required. Remove pumps and drill holes to 1/4". Deburr all holes. Place AN4-5A bolts in the other two holes and position pumps in place on firewall. Install (AN960-416 small diameter) washers on the bolts running through the diagonals and the Large penny washers on the other two bolts with the fiber lock nuts. Remove lock wire, tighten this assembly to your fire wall. Verify all connections to the pump assembly are tight.